5190/5194 Modular Tape Subsystem Manual

Installing the Modular Tape Subsystem
5190/5194 Modular Tape Subsystem Manual—426878-002
3-3
Installation Overview (NonStop Himalaya S-Series
Servers)
Before beginning the installation process, be sure to review Section 1, Introduction to
the Modular Tape Subsystem.
Installation Overview (NonStop Himalaya
S-Series Servers)
Table 3-2 lists the tasks involved in installing a modular tape subsystem.
Before beginning the installation process, be sure to review Section 1, Introduction to
the Modular Tape Subsystem.
8. Verify or set the device ID for the
tape drive CRU.
Checking and Setting the Device ID 3-41
9. Insert a new cleaning cartridge. Installing the Cleaning Cartridge in the
ACL
3-44
10. Verify that the modular tape
subsystem is ready for use.
Starting and Testing the Tape Drives
(NonStop Himalaya K-Series Servers)
3-45
Table 3-2. NonStop Himalaya S-Series Tape Subsystem Installation Tasks
Task Description Topic Page
1. Plan for the installation. Installation Planning
3-4
2. Unpack the modular storage
system.
Unpacking the Modular Storage System 3-16
3. Connect the tape drive to the
system.
Connecting the Modular Tape Subsystem 3-22
4. Use SCF to add the modular tape
subsystem to your configuration.
Configuring the Modular Tape Subsystem
Online Using SCF
2-25
5. Bring the tape drive online. Bringing the Tape Drives Online After
Installation
3-39
6. Verify or set the device ID for the
tape drive CRU.
Checking and Setting the Device ID 3-41
7. Insert a new cleaning cartridge. Installing the Cleaning Cartridge in the
ACL
3-44
8. Verify that the modular tape
subsystem is ready for use.
Starting and Testing the Tape Drives
(NonStop Himalaya S-Series Servers)
3-46
Table 3-1. NonStop Himalaya K-Series Tape Subsystem Installation
Tasks (page 2 of 2)
Task Description Topic Page