5190/5194 Modular Tape Subsystem Manual

Installing the Modular Tape Subsystem
5190/5194 Modular Tape Subsystem Manual—426878-002
3-18
Unpacking the Modular Storage System
6. Push the tall end of the ramp against the pallet to form an incline. Insert the
U-bolts into the predrilled holes to secure the ramp to the pallet.
7. With one person on each side of the modular storage system, slowly guide it off
the pallet and down the ramp. The modular storage system pedestal is on casters,
allowing you to move it easily down the ramp and into position.
a. Inspect for scratches, rust, or shipping damage. Record any damage on the
waybill. Report any damaged equipment to Compaq Computer Corporation.
Failure to report damaged equipment immediately can result in a loss of claim.
b. Make sure you have all the items listed on the packing slip that comes with the
equipment.
8. Move the modular storage system into place. Note the service clearance
information under Service Clearance and Dimensions on page 3-7.
9. Lower the cabinet legs on the pedestal. The legs are located next to each caster.
a. Turn the leg counterclockwise with your fingers until it touches the floor.
b. Using a 24-mm (15/16-inch) or adjustable, open-ended wrench, turn the nut to
secure the pad firmly on the floor.
10. Remove the foam packing piece from all tape drive CRUs that have an automatic
cartridge loader (ACL). The ACL is shipped with a disk-shaped foam insert that
supports the autoloader and prevents vibration during shipment. This piece must
be removed before you power up the tape drive CRU.
11. Now install the modular tape subsystem and connect it to the server. (See
Installing a Modular Tape Subsystem (NonStop Himalaya K-Series Servers), on
page 3-19.