5190/5194 Modular Tape Subsystem Manual

Installing the Modular Tape Subsystem
5190/5194 Modular Tape Subsystem Manual—426878-002
3-22
Installing a Modular Tape Subsystem (NonStop
Himalaya S-Series Servers)
A clearance of up to 1/8 inch between the ejector and logic board is
acceptable.
4. Perform one of the following tasks:
•
Use COUP to add the modular tape subsystem to your system configuration.
See Configuring the Modular Tape Subsystem Online Using COUP on
page 2-7.
•
Modify the CONFTEXT configuration file and run the DSM/SCM program to
create a new operating system image (OSIMAGE). See Configuring the
Modular Tape Subsystem by Modifying the CONFTEXT File on page 2-13.
Installing a Modular Tape Subsystem (NonStop
Himalaya S-Series Servers)
Refer to the Himalaya S-Series Hardware Support Guide for information on installing a
6760 ServerNet adapter with either a 6761 F-PIC or 6762 S-PIC.
Connecting the Modular Tape Subsystem
This subsection describes how to attach cables between the modular tape subsystem
and the server. Not all topics apply to all components, as indicated in Table 3-8.
Table 3-8. Modular Tape System Connecting Tasks (page1of2)
Topic Page MFC 3216
PMF/
IOMF
CRU
S-PIC/
F-PIC
Connect Cables to the Tape Drive
Opening and Removing the Rear Bezel Door
3-23 XX X X
Installing the BEB (Fiber-Optic Cables Only)
3-25 XX X
Connecting and Routing the AC Power Cords
3-26 XX X X
Connecting a Fiber-Optic Cable to the BEB
3-28 XX
Connecting a SCSI Cable
3-30 XX
Connecting a NonStop Himalaya K-Series
SCSI Cable to the Drive CRU
3-30 X
Connecting a NonStop Himalaya S-Series
SCSI Cable to the Drive CRU
3-32 X
Connect Cables to the Server
Connecting Cables to NonStop Himalaya
K-Series Servers
3-34 XX
Connecting a SCSI Cable to the MFC
RS-232/SCSI BIC
3-34 X