5190/5194 Modular Tape Subsystem Manual

Installing the Modular Tape Subsystem

5190/5194 Modular Tape Subsystem Manual—426878-002

3-24

Opening and Removing the Rear Bezel Door

The rear bezel door on a tape drive module provides access to the ports on the rear of

the tape drive CRUs. Before you can connect AC power cords or cables, you must

remove the rear bezel door from the module. Two push/pull fasteners hold the top of

the door closed. To open the rear bezel door, do the following.

1. Pull on the blue-green handle at the top. Hinges at the base of the module allow

you to lower the door to a horizontal position.

2. The hinges feature spring-loaded plungers. Pull up on the plungers to release the

hinges, and remove the rear bezel door from the module (see Figure 3-12).

Caution. Do not set heavy objects on the rear bezel door. Doing so could bend or break the

door.

Figure 3-12. Hinges on the Rear Bezel Door

Hinge

Plunger

Hinge

Cutout for

Cable Routing

VST032.vsd