5190/5194 Modular Tape Subsystem Manual

Contents
5190/5194 Modular Tape Subsystem Manual—426878-002
vii
Figures
Figure 2-2. Example of a Completed 3216 Controller BIC Diagram 2-6
Figure 2-3. Example of a Completed PMF CRU Configuration Form 2-21
Figure 2-4. Example of a Completed IOMF CRU Configuration Form 2-22
Figure 2-5. Example of a Completed 6760 Adapter and Modular Tape Subsystem
Configuration Form 2-24
Figure 3-1. Drive Placement and Device IDs for Tape Drive CRUs Attached to a
3216 Controller 3-6
Figure 3-2. Service Clearances for the Modular Storage System 3-8
Figure 3-3. Maximum Stack Height for the Modular Storage System 3-11
Figure 3-4. MFC Drive Configuration 3-12
Figure 3-5. 3216 Controller One-Drive Configuration 3-13
Figure 3-6. 3216 Controller Two-Drive Configuration 3-13
Figure 3-7. PMF CRU or IOMF CRU Drive Configuration 3-14
Figure 3-8. 6761 ServerNet/DA F-PIC With Two Drives Configured 3-15
Figure 3-9. 6762 ServerNet/DA S-PIC With Two Drives Configured 3-15
Figure 3-10. Unpacking and Removing the Modular Storage System From the
Shipping Pallet 3-17
Figure 3-11. Rear View of Two Tape Drive CRUs in a Module 3-23
Figure 3-12. Hinges on the Rear Bezel Door 3-24
Figure 3-13. Back-End Board (BEB) Enclosure 3-25
Figure 3-14. AC Power Cord Routing 3-27
Figure 3-15. Connecting Fiber-Optic Cable to the 5190/5194 BEB 3-28
Figure 3-16. Routing Fiber-Optic Cable Through the Extrusion Channel 3-30
Figure 3-17. Connecting SCSI Cable From the MFC to the Drive CRU 3-31
Figure 3-18. Routing SCSI Cable Into the Extrusion Channel 3-32
Figure 3-19. Connecting a SCSI Cable From the PMF CRU or IOMF CRU to the
Drive CRU 3-33
Figure 3-20.
Connecting SCSI Cable to the MFC RS-232/SCSI BIC 3-34
Figure 3-21.
Connecting Fiber-Optic Cable to the 3216 BIC 3-35
Figure 3-22. Connecting a SCSI Cable to the PMF CRU 3-37
Figure 3-23. Connecting a SCSI Cable to the IOMF CRU 3-38
Figure 3-24. AC Power Switch on Tape Drive CRU 3-39
Figure 4-1. Setting the File-Protect Thumbwheel on a Cartridge Tape 4-3
Figure 4-2. ACL Front Panel 4-6
Figure 4-3. ACL Cartridge Magazine 4-11
Figure 4-4. Removing the Cartridge Magazine 4-13
Figure 4-5. Cartridge Magazine Slot Numbers 4-14
Figure 4-6. Setting the File-Protect Switch on the Cartridge Magazine 4-17
Figure 4-7. Unlocking the ACL Door With the Door Release Lever 4-21
Figure 4-8. 5190 and 5194 Tape Drive CRU Front Panel 4-22