5190/5194 Modular Tape Subsystem Manual

Installing the Modular Tape Subsystem
5190/5194 Modular Tape Subsystem Manual—426878-002
3-30
Connecting a SCSI Cable
Connecting a SCSI Cable
NonStop Himalaya S-series SCSI cables are not the same as NonStop Himalaya
K-series SCSI cables. Their part numbers are listed in Appendix A.
Connecting a NonStop Himalaya K-Series SCSI Cable to the
Drive CRU
At the rear of each tape drive CRU, there are two 50-pin SCSI ports. SCSI cable links
one of these ports with the MFC RS-232/SCSI BIC. A SCSI terminator covers the
other port (see Figure 3-17).
Install the cable connector to the SCSI port on the tape drive CRU as follows:
1. Align the 50-pin cable connector with the SCSI port on the right as you face the
rear of the drive CRU. Press firmly to seat the connector.
2. Fasten the connector clips.
Figure 3-16. Routing Fiber-Optic Cable Through the Extrusion Channel
To 3216 BIC
Cable
Clamp
Extrusion
Guide
To AC
Power Source
BEB
VST027.vsd