5525B/31/32 Line Matrix Printer Code V Programmer's Reference Manual

110
Chapter 2 Command Codes
Reset
Purpose Resets the Code V to the power-up configuration.
Mode Graphics with a Standard Graphics Command selected
Format (cc) @ R (cc)-
(cc) Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your Code V
configuration.
@ Specifies one of the @ commands. Enter @ to
begin an @ command function.
R Specifies the Reset command. Enter R to reset the
printer to the power-up configuration.
(cc)- Graphics Mode CR. Enter the SFCC for your Code
V configuration immediately followed by - to end the
command sequence.
Comments The Reset command prints any pending page then resets the
Code V to the power-up configuration as selected in the “Power-
up Config.” option (see
User’s Manual ). The Code V then restarts
as if just powered up (no dynamic forms in form library, character
substitution sets reset, starts printing in upper left corner, etc.).
NOTE: Any EVFU setting in the ASCII emulations (by direct codes or Code V
(cc) L command) will not be reset (refer to page 74).
Reverse Print
Purpose Produces white characters on either a black printed background
or any of the shaded or patterned backgrounds available with the
shading and shading mask features.
Mode Graphics with an Extended Graphics Command selected
Format (cc) R
data (cc)R (cc)-
(cc) Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your Code V
configuration.
R The Reverse Print command. Enter R.
data The data characters for reverse printing.
(cc)R Following the data, enter the SFCC for your Code V
configuration and the Reverse Print command (R)
to turn off the reverse printing feature.
(cc)- Graphics Mode CR used as a sequence terminator.
Enter the SFCC for your IGP configuration
immediately followed by - to end the command
sequence.