5525B/31/32 Line Matrix Printer Code V Programmer's Reference Manual

114
Chapter 2 Command Codes
Setup Files Feature
Purpose Allows the printer to be automatically configured on startup or
reset using a specific setup file.
Comments This file is stored in Flash Memory and contains any valid
emulation command; e.g. load forms, select character. The file is
loaded in memory once and remains until replaced. The file is
replaced by overwriting with a new configuration or deleted by
loading a null configuration file.
NOTE: Download of this file requires the use of a special utility disk. The disk
is available through your authorized distributor.
Shading
Purpose Produces alphanumeric characters using a black-shaded
impression.
Mode Graphics with an Extended Graphics Command selected
Format (cc) KH
data (cc) KH (cc)-
(cc) Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your Code V
configuration.
KH The Shading command. Enter KH to turn on the
shading feature.
data The data characters to print in shaded graphics.
(cc)KH Following the data, enter the Special Function
Control Code (SFCC) for your Code V configuration
and KH to turn off the shading feature.
(cc)- Graphics Mode CR used as a sequence terminator.
Enter the SFCC for your IGP configuration
immediately followed by - to end the command
sequence.
Comments The KH feature must be turned on and off by command. Any
character data entered between the KH on and off commands is
shaded when printed. Shading commands are input as part of the
data in one of the alphanumeric commands. Reverse printing
(discussed on page 110) can be combined with shading.
When the shading feature is used, only certain dot positions are
printed (versus every dot position in the normal graphics) which
produces the shaded images. The shading
value can be changed
using the Shading Mask command discussed on page 116.