5525B/31/32 Line Matrix Printer Code V Programmer's Reference Manual

118
Chapter 2 Command Codes
Special Function Control Code Change
Purpose Changes the current Special Function Control Code (SFCC).
Mode Graphics with a Standard Graphics Command selected
Format (cc) N
x (cc)-
(cc) Represents the
current Special Function Control
Code (SFCC). Enter the specific SFCC for your
Code V configuration.
N Specifies the SFCC Change command. Enter N.
x Represents the new SFCC. Enter the ASCII
character for the new SFCC. You can set the SFCC
to any character in the range of 17 through 255.
(cc)- A Graphics Mode CR using the
new SFCC. Enter
the new SFCC, immediately followed by - to end
the command sequence.
Comments When the SFCC is changed by the N command, the change is
effective immediately, and the old SFCC is no longer recognized.
When printer power is turned off and on, the SFCC returns to the
configuration default which is defined in the selected power-on
configuration.
Example The following command changes the SFCC from the tilde (~) to
the caret (
^).
~N^^-
Symbols, Creating Standard User Defined
Purpose To create specialized standard size symbols.
Mode Graphics with an Extended Graphics Command selected
Format (cc) z
x data (cc)G
(cc) Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your Code V
configuration.
z The Create Symbol command. Enter lowercase z.
x Represents the symbol being defined. Refer to
Table 16 and the Comments. Enter a lowercase
character from a through g to specify where your
symbol is stored. Make a note of the corresponding
“Print” Value; you need this number in your Print
Symbols command when you print the symbol as
discussed on page 123.