32 Line Matrix Printer Code V Programmer's Reference Manual

Symbols, Printing

123

Symbols, Printing

Purpose Prints specialized Standard or Expanded sized symbols

previously created using the z

commands described on page

118 and page 121, respectively.

Mode Graphics with an Extended Graphics Command selected

Format (cc) Z

(cc)-

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

Z The Print Symbol command. Enter uppercase Z.

Represents the symbol to print. Refer back to Table

16. Enter the number 1 to print the registered

trademark symbol; enter the number 2 to print the

from 3 through 9 which corresponds to the

alphabetical value (“a” through “g”) you specified

where the standard sized symbol is stored; or,

enter an upper case character from A through F to

select the corresponding Expanded User Defined

Symbol.

For example, in the program example shown on

page 120, the symbol was created and stored at “a”

(^za); when the symbol was

printed

, it was

specified as 3 (^Z3).

(cc)- Graphics Mode CR used as a sequence terminator.

Enter the SFCC for your IGP configuration

immediately followed by - to end the command

sequence.