5525B/31/32 Line Matrix Printer Code V Programmer's Reference Manual

269
50 User-Defined Logo Input Error
The input parameter is not within the specified range. You must
provide either a number ranging from
3 through 9, or a character
from A through F.
51 Not defined.
52 Character Set Command Error
The character set value specified at the Character Set Selection
command (i) was not within the range of 00 through 31.
53 User-Defined Character Set Command Error
The User-Defined Character Set command (u) contains a
parameter error. This is possibly caused by an incorrect value for
n , which must be a number from 1 through 8, or the values for ca
or
fa were not within the specified ranges. The value for ca must
be one of the following 16 hex values: 21, 22, 23, 24, 25, 26, 40,
5B, 5C, 5D, 5E, 60, 7B, 7C, 7D, 7E; the value for
fa must be
between hex 20 and FF.
54-55 Not defined.
56 Logo Generation Command Error
The parameters for the ILOGO command are incorrect. Logo
values of 41-49, 4A, 4B, 4C, 61 and 62 are allowed.
57 Pixel Expansion Command Error
The parameters for the IPEXP Pixel Expansion Command are
incorrect. Expansion values of 1-255 are allowed. Horizontal and
vertical expansion values must be separated by a comma.
58 Default Font Command Error
The syntax or parameter(s) for the IFONT,S, command is
incorrect.