32 Line Matrix Printer Code V Programmer's Reference Manual

Chapter 2 Command Codes

The command sequence below also uses the Horizontal Tab

(T012,5 and T017,5) command for character spacing.

^PY^-

^E10,10,000I^T012,5^W02G^T017,5^W25P^-

^PN^-

^PY^-

^U05,05,000DOWN^W01SIDE^W10UP^-

^PN^-

Character Type

Purpose Selects a character type or character per inch (cpi) density.

Mode Graphics with a Standard Graphic Command selected

Format (cc) @ C

type

(cc)*

data

(cc)*

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

@ Specifies one of the @ commands. Enter @ to

begin an @ command function.

C Specifies the Character Type command. Enter C.

type

(cc)* Represents the type parameter. Enter one of the 2-

digit codes shown in Table 4 to select a character

type, followed by the SFCC. For example, enter

^@C17^* to select 17.65 cpi. This cpi remains

effective until a new @C command is sent.

data

The data to be printed in a selected font.

(cc)* Graphics Mode LF. Enter the SFCC for your Code

V configuration immediately followed by * to end

the command sequence.