32 Line Matrix Printer Code V Programmer's Reference Manual

Chapter 2 Command Codes

Example 2 The following example illustrates the same Vertical Duplication

command but uses the different terminator for Auto Increment/

Decrement of numeric fields updated sequentially within the

repeat. The ^* on the fourth line causes a line feed on which the

second set of Invoice data is printed. Refer to the Free Format

commands discussed on page 83 and page 85.

^PY^-^F^-

^R0002^-^M02,02,000Invoice

^J010^LS0100,0004^J000 #^Y5010+5^G^-

^R0004^-^M01,01,010Part #^Y130+2^G^-^*^ZO^-

^O^-^PN^-

Duplication, Vertical (Version II)

This command performs an enhanced function of the (cc)R command

described on page 48. The IREPV command can also operate within an

Extended Graphics command, and vertical spacing between each duplication

can be specified. You must enable the Free Format command for this

command to work properly.

Purpose Defines both the number of times data is vertically duplicated

(repeated), and the vertical spacing between each duplication.

Mode Graphics with an Extended Graphics Command selected

Format (cc) IREPV,

n, spacing

(cc)G

data

(cc)IREPE

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

IREPV, The vertical duplication command. Enter IREPV,.

Represents the number of times to duplicate the

data vertically. Enter a value ranging from 1

through 9999.