32 Line Matrix Printer Code V Programmer's Reference Manual

Fonts, Compressed Print Density

Purpose Defines the horizontal print density in characters per inch (cpi).

Mode Graphics with an Extended Graphics Command selected

Format (cc) S

f data

(cc)-

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

S The Compressed Print Density command. Enter S.

Represents the Compressed Print Density font.

Replace

with a value ranging from 1 through 9 to

select the compressed print density font as

described in Table 11. Standard print density is 10

cpi. Each character font is .1-inch high. The font

sizes are illustrated in the examples beginning on

the next page.

data

The data characters for printing in the Compressed

Print Density font.

(cc)- Graphics Mode CR used as a sequence terminator.

Enter the SFCC for your IGP configuration

immediately followed by - to end the command

sequence.

Comments Use Compressed Print Density commands as part of the

Alphanumeric command. Reverse print and rotated commands

are not available with the Compressed Print feature. Characters

selected with this command print

only

in the standard horizontal

orientation. A Reverse Print or Rotated Alphanumeric command

specified in the command sequence is ignored.

Table 11. Compressed Print Density Font Selection

Font Selected

110 cpi

212 cpi

3 13.33 cpi

415 cpi

5 17.65 cpi

6 OCR-A font at 10 cpi

7 OCR-B font at 10 cpi

8 12 cpi (full-dot)

9 15 cpi (full-dot)