32 Line Matrix Printer Code V Programmer's Reference Manual

Forms, Listing Dynamic (Version II)

Purpose Lists all previously created forms, including the form size in bytes,

used by each form name.

Mode Graphics with an Extended Graphics Command selected

Format (cc) IFORM,L (cc)G

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

IFORM,L The command to list the forms in memory. Enter

IFORM,L.

(cc)G Terminator. Enter the SFCC for your Code V

configuration immediately followed by G, the

universal terminator, or another valid Graphics

Mode command terminator to end the data.

Forms, Predefined (Version II)

Purpose Loads one of three predefined forms from memory (AIAG,

Primary Metals, and Odette). These forms are selected and

completed using the commands and legends described.

Mode Graphics with standard Graphics Command selected

Format (cc) IFORM,E

formname

.QMS (cc)G

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

IFORM,E

formname

.QMS

The command to retrieve the specified predefined

form. Enter IFORM,E

formname

.QMS.

formname

may be one of the following: AIAG,

METALS, or ODETTE.

(cc)G Terminator. Enter the SFCC for your Code V

configuration immediately followed by G, the

universal terminator, or another valid Graphics

Mode command terminator to end the data.

Comments The IFORM,E command not only loads the desired predefined

form, but provides the means to fill out the form. The following

three examples show the method of specifying the data to be

placed on the forms.