32 Line Matrix Printer Code V Programmer's Reference Manual

Forms, Resetting Dynamic (Version II)

Purpose Resets dynamic form memory by deleting all forms stored in

memory.

Mode Graphics with an Extended Graphics Command selected

Format (cc) IFORM,R (cc)G

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

IFORM,R The command to reset forms memory. Enter

IFORM,R.

(cc)G Terminator. Enter the SFCC for your Code V

configuration immediately followed by G, the

universal terminator, or another valid Graphics

Mode command terminator to end the data.

Comments Standard predefined forms will not be deleted from forms memory

with this command. If predefined forms were previously deleted,

they will be reinstalled in the forms memory after execution of this

command.

Free Format (Enable/Disable)

Purpose Enables the Code V to ignore all host generated paper motion

commands ranging from hex 00 through 1F.

Mode Graphics with a Standard Graphics Command selected

Format (cc) F (cc)-

data

(cc) O (cc)-

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

F Specifies the Free Format command. Enter F.

(cc)- Graphics Mode CR. Enter the SFCC for your Code

V configuration immediately followed by - to end the

command sequence.

data

Represents the data, commands, and all other

codes for processing in the Free Format. All Code

V features are available when Free Format is

enabled.

(cc)O Turns off the Free Format mode. Following the data

for processing in the Free Format, enter the SFCC

for your Code V configuration immediately followed

by O (alpha O) to end the Free Format.

(cc)- Graphics Mode CR. Enter the SFCC for your Code

V configuration immediately followed by - to end the

command sequence.