32 Line Matrix Printer Code V Programmer's Reference Manual

Chapter 2 Command Codes

Graphics Mode Disable

Purpose Exits the Code V from Graphics Mode and returns to the Normal

Mode.

Mode Graphics

Format (cc) PN (cc)-

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

PN Specifies the Graphics Mode Disable command;

enter PN.

(cc)- Terminator. Enter the SFCC for your Code V

configuration immediately followed by - (Graphics

Mode CR) or other valid terminator.

Example The following command disables the Graphics Mode.

^PN^-

Hex Dump

Purpose Prints all data in hexadecimal code equivalent.

Mode Graphics with a Standard Graphics Command selected

Format (cc) @ H 0 (cc)-

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

@ Specifies one of the @ commands. Enter @ to

begin an @ command function.

H Specifies the Hex Dump command. Enter H.

0 Specifies the Hex Dump parameter. Enter 0 (zero).

(cc)- Graphics Mode CR. Enter the SFCC for your Code

V configuration immediately followed by - to end the

command sequence.

Comments The @H command is available when the Code V is in the

Graphics Mode. When the @H command is used, the front panel

option “Hex Dump Mode” is set to Enable automatically. To

disable the hex dump, place the printer offline and change the

“Hex Dump Mode” parameter from Enable to Disable. Refer to

your

User’s Manual

for instructions.