32 Line Matrix Printer Code V Programmer's Reference Manual

Line Spacing

Purpose Selects a new line spacing in lines per inch (lpi).

Mode Graphics with a Standard Graphics Command selected

Format (cc) @ L

newlpi

(cc)-

(cc) Represents the Special Function Control Code

(SFCC). Enter the specific SFCC for your Code V

configuration.

@ Specifies one of the @ commands. Enter @ to

begin an @ command function.

L Specifies the Line Spacing command. Enter L to

change the line spacing.

newlpi

Represents the line spacing parameter. Enter one

of the two-digit codes shown in Table 13 to select a

new line spacing. For example, enter 10 to select

10 lpi.

Not all values are available on all printer models.

Check the

User’s Manual

for the line spacing

options available.

Once the new line spacing is selected, all lines are

printed at the new lpi setting until another line

spacing is selected or the Code V returns to the

Normal Mode.

(cc)- Graphics Mode CR. Enter the SFCC for your Code

V configuration immediately followed by - to end the

command sequence.

Table 13. Line Spacing Codes

Line Spacing Code Line Spacing (lpi) Selected

01 1

02 2

03 3

04 4

06 6

08 8

09 9

10 10

12 12

18 18

72 72