5525B/31/32 Line Matrix Printer IGP/PGL Programmer's Reference Manual

138
Chapter 3 Bar Codes
I-2/5 Command Format
BARCODE
I-2/5 [CD];
or
I25GERMAN; or
ITF14; [ DIR ;] [ MAG ;] [H n [. m ];] [BF n;L; ] [DARK;] SR; SC
[ (D)data field(D) ]
[PDF [;
LOC ] [; FONT ]]
STOP
BARCODE The Bar Code command; enter BARCODE.
I-2/5 CD Designates bar code type Interleaved 2/5; enter
I-2/5. To calculate and plot the optional modulo-10
check digit with the bar code symbol automatically,
enter CD.
I25GERMAN Designates German Interleaved 2/5; enter
I25GERMAN. The mod-10 check digit is
automatically included.
ITF14 Designates ITF-14; enter ITF14. The mod-10 check
digit is automatically included.
DIR Optional parameter that allows for rotating a
barcode. Enter CW for clockwise rotation. Enter
CCW or VSCAN for counter-clockwise rotation.
Enter INV for inverted rotation. If
DIR is not
entered, the barcode is horizontally oriented.
MAG Optional parameter to magnify (horizontally
expand) the bar code symbol. The magnification
default value is X1. As required for scanning, enter
a magnification value from Table 8 or Table 9 to
increase the magnification. Increasing the
magnification adjusts printed character density.
You can also use XR or XRD as defined on page
89.
H
n [ .m ] Optional parameter to adjust the overall height
(vertical expansion) of the bar code symbol
(including the upper and lower 0.1-inch guard
bands and any human readable data). Height
adjustments are made in 0.1-inch increments; enter
H and a value from 3 through 99 to select height
adjustments from 0.3 through 9.9 inches. The
default value is 0.9-inch. The [
.m ] provides an
additional number of dots for the bar code height.
(Dots are in the current dot scale.)
NOTE: If 0.3 inches is the selected height, the PDF cannot be included.