PGL Programmer's Reference Manual

Creating a Form and Adding Form Components

235

10. Add the logo and end the Create Form mode. Use the Logo Call

command, specify the starting row (

) at 12 and column (

) at 18 as

shown on the grid and call the logo by name (HANDCRFT). The starting

row and column of the logo refer to the upper left corner of the grid used

in the logo design.

Enter Format

LOGO LOGO

12;18;HANDCRFT

SR;SC;logoname

STOP STOP

END END

11. Execute the form (HCBOATS), return to the Normal mode (remember the

blank line before the NORMAL command), exit the file using your system

commands (if necessary), and print the document.

Enter Format

~EXECUTE;HCBOATS (cc)EXECUTE;

formname

[;PAGE

][;

]

~NORMAL (cc)NORMAL

.PRINT HNDCFT.FOM (System Format)

NOTE:

Always

separate the EXECUTE and NORMAL commands by a blank

line.

Figure 53 shows the finished form. If Mr. Handcraft would like to rearrange the

words, change line thickness of a box, etc., simply open the file and change

the appropriate command lines. Otherwise, his salespeople have a new form

for notes on custom orders.