5525B/31/32 Line Matrix Printer IGP/PGL Programmer's Reference Manual

46
Chapter 2 Command Codes
Configuration
Purpose Places the IGP/PGL in the Configuration mode, where changes
to any or all of the IGP/PGL configuration parameters via
software control can be made instead of from the printer control
panel.
Mode NORMAL
NOTE: A separate line is required for the CONFIG command, the parameters
and values, and the END command.
Format (cc)CONFIG
parameter;value
END
(cc) The Special Function Control Code.
CONFIG The Configuration command; enter CONFIG.
parameter;value
The parameter for which a configuration change is
desired, and the value associated with that
parameter. The available parameters and the
values associated with these parameters are listed
in Table 6.
END Terminates the CONFIG command; enter END.
NOTE: All CONFIG parameters must be followed by a semicolon (;). Any
CONFIG parameters not entered in UPPERCASE and exactly as
listed in Table 6 will result in an Error 156. (Refer to the “Error Codes”
chapter.)