5525B/31/32 Line Matrix Printer IGP/PGL Programmer's Reference Manual

60
Chapter 2 Command Codes
EVFU Data Optional parameter to use the EVFU to overlay
data onto the form. (“EVFU Data” is not part of the
Execute command. It is shown in the command
sequence to indicate that actual EVFU data can be
entered following the Execute command.) Enter
EVFU data as described in Appendix C and on
page 61.
(cc)AF
n;(D)ASCII text(D)
The Execute Dynamic Alphanumeric Data
command. Enter the dynamic alphanumeric data
during the Execute Form mode as described in
“Execute Form: Dynamic Alphanumeric Data” on
page 62.
(cc)BF
n ;(D)data(D)
The Execute Dynamic Bar Code Data command.
Enter the dynamic bar code data during the
Execute Form mode as described in “Execute
Form: Dynamic Bar Code Data” on page 63.
(cc)IAF
n; [ idir ] STEPMASK; [RPT n; ] [RST n ;] (D)STARTDATA(D)
The Execute Incremental Dynamic Alphanumeric
Data command. Supply the data as described on
page 65.
(cc)IBF
n; [ idir ] STEPMASK; [RPT n; ] [RST n ;] (D)STARTDATA(D)
The Execute Incremental Dynamic Bar Code Data
command. Supply the data as described on page
65.
Overlay Data Overlay data can be entered during the Execute
Form mode. (The words “Overlay Data” are not part
of the Execute command. They are shown in the
command sequence to indicate that actual overlay
data can be entered following the Execute
command.) Refer to “Execute Form: Overlay Data”
on page 66.
Form Feed Character
Optional command instructing the IGP/PGL to start
a new page with new EVFU, dynamic, and overlay
data using the existing Execute commands for the
current form. This EVFU Data-Dynamic Data and
Overlay Data-Form Feed Character sequence can
be repeated indefinitely, while maintaining the
optimum print speed, within the original Execute
command.