PGL Programmer's Reference Manual

Chapter 2 Command Codes

Ignore Sequence

Purpose Enables the IGP/PGL to ignore all characters after the Ignore

Sequence On (IGON) command is entered. All characters are

ignored until the Ignore Sequence Off (IGOFF) command is

entered.

Mode NORMAL, CREATE, or EXECUTE

Format (cc)IGON or (cc)IGOFF

NOTE: A line terminator is not required in the Ignore Sequence.

(cc) The Special Function Control Code.

IGON Ignore Sequence On command; enter IGON.

IGOFF Exits Ignore Sequence; enter IGOFF.

Comments IGON and IGOFF can also be used anywhere in the data stream.

Line Spacing

Purpose Defines the lines per inch (lpi) printing format.

Mode NORMAL, EXECUTE

Format (cc)LPI;

(cc) The Special Function Control Code.

LPI The Vertical Line Spacing command; enter LPI.

Selects the line spacing in lpi; enter 6, 8, 9, or 10.

Comments Standard line spacing is 6 lpi. After a Vertical Line Spacing

command is entered, all subsequent alphanumerics print at the

specified lpi until another Vertical Line Spacing command, a

Normal Mode command, or a Reset command is entered.

Example The following command selects 9 lpi printing format until another

Line Spacing command, a Normal Mode command, or a Reset

command is entered.

~LPI;9