PGL Programmer's Reference Manual

Chapter 2 Command Codes

Setup

Purpose Automatically executes and loads IGP/PGL commands such as

forms, logos, customized print environments, etc., from flash

memory to the printer whenever printer power is applied or when

the RESET command (page 81) is sent.

Mode NORMAL

Format (cc)SETUP

HOST DATA

(cc)SETUPEND

(cc) The Special Function Control Code.

SETUP The Setup command; enter SETUP.

HOST DATA

Any IGP/PGL commands, form definitions, text, etc.

to be stored and executed at power-up.

SETUPEND Finishes storing host data and returns the printer to

the NORMAL mode. Enter SETUPEND.

Comments Because the RESET command causes the setup routine to be

executed, the RESET command can not be in the SETUP

information or else an infinite loop will occur.

If IGP/PGL commands have not been added between the SETUP

and SETUPEND commands, the SETUP.PTX file on the flash

memory is automatically deleted, and no IGP/PGL SETUP

commands are executed upon printer power-up.

NOTE: The SETUP.PTX is automatically created by the IGP/PGL when the

~SETUPEND command is received. When the SETUP.PTX file is not

in the flash memory, no extra IGP/PGL commands are performed on

power up.