5525B/31/32 Line Matrix Printer LinePrinter Plus Programmer's Reference

108
Chapter 4 Configuring the Epson FX-1050 Emulation with Control Codes
the double wide attribute set by SO. No other print attributes are
affected. The logical print head goes to the print position it had
after the last CR or paper motion command.
Carriage Return
ASCII Code CR
Hex Code 0D
Dec Code 13
Purpose Prints the data in the buffer, then returns the logical print head to
the left margin.
Discussion Subsequent data are shifted 1/2 dot position to the right. A line
feed will be appended if the printer is configured from the control
panel for CR = CR + LF. When CR = CR + LF, this code cancels
all one-line-only emphasis and font controls: double-wide from
SO and ESC SO, and unidirectional printing from ESC <.
Character Pitch 10 CPI
ASCII Code ESC P
Hex Code 1B 50
Dec Code 27 80
Purpose Sets character pitch to 10 characters per inch (cpi).
Discussion This command is normally used to cancel 12 cpi.
Character Pitch 12 CPI
ASCII Code ESC M
Hex Code 1B 4D
Dec Code 27 77
Purpose Sets character pitch to 12 characters per inch (cpi).
Discussion This command is available in all print modes except OCR A and
OCR B.
Character Pitch 15 CPI
ASCII Code ESC g
Hex Code 1B 67
Dec Code 27 103
Purpose Sets character pitch to 15 characters per inch (cpi).
†Discussion This command is not defined in Epson FX printers. It is included
in this emulation for compatibility with the Okidata KX-P1180
printer. This command is available in all print modes except OCR
A and OCR B.