32 Line Matrix Printer LinePrinter Plus Programmer's Reference

Chapter 2 Configuring the P-Series Emulation with Control Codes

Attribute Set and Reset Codes

Certain print attributes are set and reset (turned on or off) by using the

appropriate SFCC code sequence and the numbers 1 or 0. These may be

either the hexadecimal code 01 and 00, or the ASCII code for the printable

symbols of decimal 1 and 0 (hexadecimal code 31 and 30, respectively).

Expanded Print, Super/Subscript Print, and Underline are attributes that are

set/reset this way.

NUL Code

NUL (hex 00) is ignored by the printer and can be used as a fill character;

however, it can not be used to add blank spaces since it is not a space

character.

NOTE: Hex 80 in the 0437 PC Character Set and hex 7F in the 0850 PC

Character Set are treated as a NUL; however, these two controls can

not be used as parameter terminators.

Print Modes Supported for Character Sets

All print modes are supported for all character sets; however, for the character

sets listed in Table 4, only the print modes listed are supported.

Table 4. Print Modes Supported

Character Set Mode Pitch

Barcode 10 cpi DP 10

Multinational DP 10 cpi DP 10

Multinational DP 12 cpi DP 12

Multinational NLQ 10 cpi NLQ 10

Greek DP 10 cpi DP 10

Greek DP 12 cpi DP 12

Greek NLQ 10 cpi NLQ 10

Graphic DP 10 cpi DP 10

Graphic NLQ 10 cpi NLQ 10

Scientific DP 10 cpi DP 10

Scientific DP 12 cpi DP 12

Scientific NLQ 10 cpi NLQ 10

OCR-A OCR-A 10

OCR-B OCR-B 10