5525B/31/32 Line Matrix Printer LinePrinter Plus Programmer's Reference

The Control Codes
25
The Control Codes
This index lists each printer command by function, ASCII mnemonic, and the
page where the command is explained in detail. “N/A” means not applicable.
The rest of this chapter defines the control code functions for P-Series
Emulation mode. The commands are listed in alphabetical order.
NOTE: Some control code functions can be accomplished using another
control code sequence or via control panel selection.
FUNCTION ASCII CODE PAGE
Paper Motion
Form Feed FF 40
Line Feed LF 42
Reverse SFCC } ;
n 51
Vertical Tab VT 53
Page Format
Backspace BS 27
Carriage Return CR 29
Forms Length Set (Inches) SFCC INCHES;
n.f 41
Forms Length Set (Lines) SFCC LINES;
n 41
Line Spacing 1/6 Inch (6 lpi) SFCC 2 42
SFCC LPI
Line Spacing 1/8 Inch (8 lpi) SFCC 0 43
SFCC LPI
Line Spacing 8 or 10.3 LPI ACK 43
(1 line only) SFCC f
Line Spacing 7/72 Inch SFCC 1 44
Line Spacing
n /72 Inch SFCC A 45
Line Spacing
n /216 Inch SFCC 3 46
VFU Commands N/A 53
Print Attributes
Bold Print SFCC G 28
Bold Print (1 line only) SFCC j 28
Bold Print Reset SFCC H 28
Elongated (Double High) Print,
One Line Only SFCC h 35
Elongated (Double High) Print,
Set/Reset SFCC w
n 36
Emphasized Print SFCC E 36
Emphasized Print Reset SFCC F 37
Expanded Print (Double Wide)
One Line Only SFCC k 38
Expanded Print (Double Wide) SFCC W
n 38
Overscoring SFCC _
n 46
Print Mode/Pitch Selection SFCC X
m n 48
SFCC PMODE;
n
SFCC [ n q