32 Line Matrix Printer LinePrinter Plus Programmer's Reference

Chapter 2 Configuring the P-Series Emulation with Control Codes

Character Set Select: ECMA Latin 1 Extended

ASCII Code SFCC OSET;

Purpose Selects the print mode and pitch at which the extended

characters will print. Valid only if the ECMA Latin 1 Extended

Character Set is selected; otherwise, this command is ignored.

Discussion

ranges from 0 through 12 (hex 00 through 0B) to select the

print mode/pitch combinations available from Table 8. All other

values will result in an error message.

OSET is valid

only

when the ECMA Latin 1 character set has

been selected from the control panel. OSET will be ignored if the

IBM PC, Multinational, or DEC Multinational Character Sets are

active.

Extended characters will print at the print mode and pitch

selected by the OSET command, even if that mode and pitch

differs from the currently selected print mode and pitch. If the

print mode differs between the extended and primary characters,

the first character in the data stream selects the print mode at

which that line will print. Different pitches can be printed on the

same line.

Table 8. Print Modes/Pitches Available Using P-Series OSET

(ECMA Latin 1, Extended Character Set Only)

Print Mode/Pitch Select

0 Barcode DP 10 cpi

1 Multinational DP 10 cpi

2 Multinational DP 12 cpi

3 Multinational NLQ 10 cpi

4 Greek DP 10 cpi

5 Greek DP 12 cpi

6 Greek NLQ 10 cpi

7 Graphics DP 10 cpi

8 Graphics NLQ 10 cpi

9 Scientific DP 10 cpi

10 Scientific DP 12 cpi

11 Scientific NLQ 10 cpi

12 Multinational at Primary Character Set Mode

and Pitch