5525B/31/32 Line Matrix Printer PCL II Programmer's Reference Manual

12
Chapter 2 Introduction
HP PCL-II Emulation Default Settings
The factory settings for the PCL-II emulation menu options are shown in
Table 1. Host control codes can override the settings for these menu options.
Switching Between the Emulations
The printer supports four emulations: PCL-II (the default), LinePrinter Plus,
Code V™ and IGP
®
/PGL
®
. The LinePrinter Plus has three protocols from
which to choose: P-Series, Proprinter III XL, and Epson FX-1050.
You can switch between PCL-II and any of the LinePrinter Plus protocols by
sending one of the following commands:
ESC%-00000X Switches from PCL-II to P-Series
ESC%-00001X Switches from PCL-II to Proprinter III XL
ESC%-00002X Switches from PCL-II to Epson FX-1050
SFCC|};K0 Switches from any of the LinePrinter Plus emulations
to PCL-II
Table 1. PCL-II Menu Option Factory Settings
Parameter Default Setting
Primary/Secondary Character Set
ID 0
Symbol Set Roman-8(8U)
Pitch 10.0 cpi
Density Data Processing
Page Length Representation Inches/Page
Graphics Density 60 dpi
Perforation Skip Disable
Display Functions Disable
LF after CR Disable
CR after LF Enable
CR after FF Enable
CR after VT Enable
PTX Linefeed Disable
LPI Adjust 6 LPI
Page L. /Lines 66 lines
Page L. /Inches 11 Inches