5525B/31/32 Line Matrix Printer User's Manual
Table Of Contents
- 1 Introduction
- 2 Setting Up the Printer
- 3 Operating the Printer
- 4 The Configuration Menus
- Configuration Overview
- CONFIG. CONTROL
- ACTIVE EMULATION
- EMULATION
- PCL-II Emulation
- LinePrinter Plus Emulations
- Optional Emulations
- PCL-II Emulation
- LinePrinter Plus Emulation
- P-Series Emulation
- Proprinter XL Emulation
- Epson FX Emulation
- IGP/PGL Submenu
- Features
- Configuring the Emulation with the Control Panel
- Define CR Code (Carriage Return)
- Define LF Code (Line Feed)
- Autowrap
- Select SFCC
- PI Slew Range
- CR Edit
- Select Font
- Select LPI
- Auto Uppercase
- Skip Command Prefix
- Power On IGP/PGL
- Extended Execute Copy
- UPC Descenders
- Compressed CPI
- Ignore Character
- IGP100 Compatbl.
- Optimized Ratio
- IGP/VGL Emulation
- MAINT / MISC
- HOST INTERFACE
- ETHERNET PARAMETERS
- PRINTER CONTROL
- DIAGNOSTICS
- RIBBONMINDER
- 5 Interfaces
- Overview
- Dataproducts Long Line Interface
- IEEE 1284 Parallel Interface
- RS-232 and RS-422 Serial Interfaces
- Host System Configuration
- Internal Ethernet Adapter Configuration
- Configuring the Internal Ethernet Adapter for TCP/IP
- Host Software
- Compiling Host Software
- Computer-aided Configuration with ezsetup or npconfig
- Configuration Through the Network with ARP
- Configuration Through the Network with RARP
- Configuration Through the Network with BOOTP
- Restoring Factory Defaults
- Host Configuration
- Direct Printing Without Spooler
- Printing Via the Spooler
- Custom Interface Scripts
- BSD UNIX
- System V UNIX
- npd Pseudo-device Interface
- Other TCP/IP Methods
- Configuring The Internal Ethernet Adapter For Novell
- Configuring the Internal Ethernet Adapter for Windows
- 6 Troubleshooting
- A Printer Specifications
- B Downloading Firmware
- C ASCII Character Set
- D Communication and Trademark Information
Index
232
Page Length Representation, 77
PAP BAD TABLE * message, 203
PAP BSY TOO LNG * message, 203
PAP FIFO OVERFL * message, 203
PAP FIFO UNDRFL * message, 203
PAP ILLGL ST * message, 204
PAP INCMPL ENER * message, 204
PAP INVLD CMD * message, 204
PAP INVLD PARM * message, 204
PAP NOT SCHED * message, 204
PAP NT AT SPEED * message, 204
PAP UNEXP INT * message, 204
Paper
jams, 201
loading, 34
specifications, 208
Paper chains
cabinet model, 23
Paper Instruction (PI) signal
Dataproducts Long Lines interface,
133
Paper Out Dots, 127
Parity, 118
PARITY ERROR message, 204
Perforation Skip, 82
Perforation, skipping, setting with control
panel, 77
PI Control, 110
PI Ignored, 114
PI Slew Range, 97
PLAT INV CMD * message, 204
PLAT INV PARM * message, 204
PLAT INV STATE * message, 204
Plot rates, 212
PMD (Paper Motion Detection) Fault, 123
Power
consumption, 211
requirements, 15, 211
Power On IGP/PGL, 98
Power Paper Stacker
Unloading Paper, 55
POWER SAVER MODE message, 205
Power Saver Time, 124
POWER SUPPLY HOT * message, 204
Powering on the Printer
Printer selftest, 41
Power-Up Config, 72
Power-Up State, 112
PREV or NEXT key, 46
Primary Character Set, 76
Prime Signal, 115, 120
Print Char Set, 80
Print Config, 72
Print Job
canceling, 60
Print Statistics, 127
Printer
dimensions, 209
features, 11
installation, distance required from
host, 16
interfaces, 131
maintenance, 14
models, 11