6100 ADCCP Programming Manual

Status Code Definitions
Requests and Responses
6–54 069225 Tandem Computers Incorporated
Table 6-8 lists status codes that indicate a fatal modem error occurred.
Table 6-8. Status Codes Indicating a Fatal Modem Error
Status
Code
Next
State Definition Recovery
32 STOPPED The modem reset the DSR signal, disconnecting the
line.
Try to connect the line again, using START or
MODEM CONTROL. If the problem persists
or occurs frequently, test the modem for a
possible disorder. You might also use
FETCH STATISTICS to find out the state of
the DTR signal; there could be something
wrong on the LIU side of the interface.
33 STOPPED The modem reset the transmit clock, disconnecting
the line.
Test the modem for a possible disorder.
34 STOPPED/same The modem reset the DCD signal unexpectedly. If you specified the NOCARRFATAL option,
the line is now disconnected; if not, the line
state has not changed. Test the local and
remote modems for for possible disorders.
You can also use FETCH STATISTICS to find
out the state of the RTS signal; there could be
something wrong on the LIU side of the
interface.
35 STOPPED/Same The modem reset the CTS signal unexpectedly. If you specified the NOCARRFATAL option,
the line is now disconnected; if not, the line
state hasn’t changed. Test the local and
remote modems for possible disorders. You
might also use FETCH STATISTICS to find
out the state of the RTS signal; there could be
something wrong on the LIU side of the
interface.
36 Same The modem did not assert DSR within the expected
time interval, or did not drop DSR within the expected
time interval.
The time interval is determined by the
DSRTIMER parameter. Possible causes for
this problem are a modem malfunction, a
problem on the LIU side of the interface, (for
example, a bad DTR signal), or a DSRTIMER
value that is too low for the application. See
the description of DSRTIMER in Section 1,
“Introduction to 6100 ADCCP.”
39 Same DSR came up (V.25 only - V.25 terminated). The modem is not configured for V.25.