6100 BSC Programming Manual
File System Error Codes
----------------------------------------------------------------
22 Invalid request ID. The request ID in the WRITEREAD
buffer is 0 or negative. Change it to a number
between 1 and 32767. (CP6100 doesn't check for
duplicate request IDs. Your application must manage
its own request IDs, in coordination with other
applications using the line.)
----------------------------------------------------------------
53 File management interface error. Probably your
application issued another request after closing
the line. Open the line again, and then repeat
your request.
----------------------------------------------------------------
60 Invalid Open ID or Not Open. You made a request of
a line or device without first opening it. Either
you forgot the OPEN call, a failure occurred during
that call and you didn't reissue it, or the line was
downloaded after being opened (with the SYSGEN
AUTOCLOSE parameter set). Open the line; if the
line was downloaded after being opened, close it and
open it again.
----------------------------------------------------------------
61 Device Suspended. The line or device is unable to
accept OPEN requests. An operator used CMI to
suspend the device; have the operator activate the
device, and then repeat the operation.
----------------------------------------------------------------
66 Device Down. The line or device cannot accept any
requests; perhaps an operator used CMI to stop the
device, an error condition caused CP6100 to stop the
device, or the line interface unit has not been
downloaded yet. This message can also mean that
the protocol rejected the configuration block.
Check the console for messages about a possible
hardware failure. Ensure that there is power to the
subsystem cabinet; then have the operator use CMI to
download and start the line interface unit; finally,
repeat your request. If the error persists, contact
your Tandem representative.
----------------------------------------------------------------
99 No License for Protocol Software. There is probably
something wrong with the software license PROM.
Contact your Customer Engineer.
----------------------------------------------------------------
A-6