6530 Programmer's Guide
Overview
6530 Programmer’s Guide
1-23
screen saver 
Selects the time interval (in minutes) for the screen saver feature. Set by 
the Esc v P sequence. For conversational mode, see “Set Terminal 
Configuration (Esc v)” on page 2-30. For block mode, see “Set Terminal 
Configuration (Esc v)” on page 3-59.
session name 
Only used on a Multilan connection when the 6530 is running under 
MS-DOS. Sets the name for a 6530 session when using a nonswitched 
access mode. This allows the user to terminate the 6530 without 
automatically being logged off of the host process. This parameter is set 
by the user. For more information, see the PC6530 or TS530 user’s guide, 
or the Multilan documentation.
SPS 
Only used on a Multilan connection. Sets the startup parameter string (if 
needed) for a host process when establishing a dynamic link. The host 
process to be started is specified by the resource name parameter. This 
parameter is set by the user. For more information, see the PC6530 or 
TS530 user’s guide, or the Multilan documentation.
status line border
Designates whether the status line (the last line on the page) is separated 
from the rest of the lines by a border. This parameter is supported on read 
operations only; you cannot change the designation. This parameter is set 
by the user. For more information, see the PC6530 or TS530 user’s guide.
transmit line 
Sets a string that is automatically transmitted to the host system when the 
6530 is started. For example, this can be used to send a command to the 
host or transmit modem commands over the communications line. This 
parameter is set by the user. For more information, see the PC6530 or 
TS530 user’s guide.
TS530 screen video 
attributes
Allows TS530 display configuration for: no screen display, reverse video, 
and reverse video with overscan. This parameter is set by the user. See the 
TS530 user’s guide for more information.
TS530 switch 
refresh rate
Allows switching of TS530 display refresh rate between 71 and 82Hz. 
This parameter is set by the user. See the TS530 user’s guide for more 
information.










