6760 ServerNet/DA Manual

6760 ServerNet/DA Manual—424879-003
C-1
C
SCF Storage Subsystem Events
This appendix summarizes the events associated with the SCF storage subsystem.
The events are described beginning on page C-2.
For detailed information about these events see:
•
Operator Messages Manual
•
Compaq NonStop Kernel Event Management Programming Manual
If You Have to Contact Your Service Provider
If you need to contact your service provider, you should be prepared to supply a log file
with the information produced by the following steps. (If the error caused SCF to
terminate, reenter SCF.)
1. Enter an SCF LOG command to collect the following displays into a single file; for
example:
-> LOG $DATA00.LOGINFO.OCT14
2. Enter an SCF LISTPM command to collect information about the product versions
of the SCF components, a list of the product modules on your system, and
information about any product modules running when the error occurred; for
example:
-> LISTPM
3. Enter an SCF ENV command to collect information about the SCF environment
that was present when the error occurred; for example:
-> ENV
If the error forced SCF to terminate, be sure to specify any environmental
characteristics that were present when the error occurred.
4. Enter SCF DETAIL CMDBUFFER and RSPBUFFER commands to capture the
contents of the Subsystem Programmatic Interface (SPI) command and response
buffers; for example:
-> DETAIL CMDBUFFER ON
-> DETAIL RSPBUFFER ON
5. Reproduce the sequence of commands that produced the event message.
6. Close the log file.
-> LOG