6760 ServerNet/DA Manual

Installing and Moving the 6760 ServerNet/DA
6760 ServerNet/DA Manual—424879-003
2-17
Connect External Devices
3. Push the cable connector into the appropriate SAC port on the adapter. Make sure
that the connector is properly seated by pushing on the connector again, and then
tighten the thumbscrews (see Figure 2-8).
4. Label both ends of the SCSI cable so that when cables are removed in the future,
you can determine the proper location of each cable. For example, if the cable
connects SAC 1 of the adapter in slot 54 of processor enclosure 02 to tape drive
$TAPE00, you could make the following label:
G02S54SAC1TP00 (Group 02, Slot 54, SAC 1, tape drive $TAPE00)
5. When all the cables are connected to the adapter, remove the ESD wriststrap from
your wrist and disconnect the grounding clip. Store the ESD kit in a convenient
location.
6. Use a cable tie to secure the SCSI cables to a cable support below the adapter
(see Figure 2-7).
Continue with Test the 6760 Adapter on page 2-18.
Figure 2-8. Connecting a SCSI Cable to a 6762 S-SAC
016CDT .CDD
Adapter Faceplate
SCSI-2 Connector
1. Make sure the longer side of the connector is
on the left.
2. Insert the cable connector into the SAC port.
3. Tighten the thumbscrews.