6760 ServerNet/DA Manual

Configuring the 6760 ServerNet/DA and Attached

Devices

6760 ServerNet/DA Manual—424879-003

3-16

Example: INFO TAPE Detailed Report

To view detailed configuration information about a tape drive, use the SCF INFO TAPE,

DETAIL command. The following command produces a report such as the one shown

in Example 3-5.

-> INFO TAPE $TAPE0, DETAIL

This report shows that $TAPE0:

•

Is controlled by a 6760 adapter (denoted as SNDA)

•

Has processor 0 assigned as the primary processor

For other details concerning this display, see SCF Reference Manual for the Storage

Subsystem.

SAC Name shows the name of the SAC this device is connected to.

The name is determined by concatenating the adapter type

with the adapter location and the physical location of the

SAC in the adapter.

SAC ID shows the identification address of the SAC this device is

connected to. For SCSI devices, this address is either 6 or

7. For fiber-optic devices the SAC ID is the same value

shown in the SAC Sub Device field.

SAC Sub Device shows the physical location in the adapter of the SAC this

device is connected to. For devices connected to a 6760

adapter, this number can be 1, 2, 3, or 4 depending on how

many SACs are installed.

Example 3-5. INFO TAPE, DETAIL Display

STORAGE - Detailed Info TAPE configuration \ALM171.$TAPE0

AdapterName.......................... $ZZSTO.#SNDA.GRP-1.MOD-1.SLOT-54

*Adapter Location (Group,Module,Slot). (1,1,54)

*BackupCpu............................ 1

*Compression.......................... ON

*Density.............................. 6250

*DeviceID............................. 5

*HighPin.............................. ON

*MaxOpens............................. 2

*PrimaryCpu........................... 0

*Program.............................. $SYSTEM.SYSTEM.OTPPROCP

*RecSize.............................. 2048

SAC Name..............................$ZZSTO.#SNDA.SAC-1.GRP-1.MOD-1.SLOT-54

*StartState........................... STARTED