6760 ServerNet/DA Manual

Configuring the 6760 ServerNet/DA and Attached
Devices
6760 ServerNet/DA Manual—424879-003
3-17
Example: INFO TAPE Detailed Report
INFO TAPE Detailed Report Information
The following describes the fields displayed in an INFO TAPE, DETAIL report, such as
the one shown in Example 3-5:
AdapterName shows the name of the adapter that the tape drive is attached to (a
6760 adapter in Example 3-5).
Adapter Location (Group, Module, Slot)
shows the physical location of the adapter that the tape drive is
attached to.
BackupCpu shows the processor number of the backup tape process.
Currently, this processor must reside in the group where the
adapter is installed.
Compression for the cartridge tape drives, shows whether compression is
configured (ON) or not (OFF). This setting is ignored by the 5194
tape drive, because compression is always on. For other tape
drives, this field is not applicable (N/A).
Density shows the configured tape density in bits per inch (bpi) of a 5170
tape drive. This value applies only to 5170 tape drives. This
attribute is ignored by all other tape drives.
DeviceID shows the DEVICE ID that is configured for the device. This ID
must match the SCSI ID that is physically set in the device.
HighPin shows whether the tape process is allowed to run at a high PIN
(ON) or only a low PIN (OFF).
MaxOpens shows the maximum number of concurrent open files allowed for
the tape drive.
PrimaryCpu shows the processor number of the primary tape process.
Currently, this processor must reside in the group where the
adapter is installed.
Program shows the object file name of the tape process.
RecSize shows the configured record size (in number of bytes) for the tape
drive.
SAC Name shows the name of the SAC in the 6760 adapter. This value is
determined by the SAC number and the physical location of the
adapter.
StartState shows whether the tape process is enabled (in the STARTED state)
or disabled (in the STOPPED state) when the system is loaded.