6760 ServerNet/DA Manual

Operating the 6760 ServerNet/DA
6760 ServerNet/DA Manual—424879-003
4-18
Adding, Removing, and Replacing Devices
a. Issue the SCF SWITCH command to change each device path, if possible, to
another adapter. For example:
-> SWITCH $DISKOO-B
-> SWITCH $DISKO1-B
-> :
-> :
-> SWITCH $DISKO6-B
-> SWITCH $DISKO7-B
b. Use the SCF STOP DISK command to stop each device path. For example:
-> STOP $DISKOO-P
-> STOP $DISKO1-P
-> :
-> :
-> STOP $DISKO6-P
-> STOP $DISKO7-P
c. Issue the SCF STATUS ADAPTER command again to verify that all the paths
using the affected adapter are stopped.
Adding, Removing, and Replacing Devices
For information about installing and replacing internal devices in general, refer to the
NonStop S-Series Hardware Support Guide.
For general information about the 45xx modular disk subsystem and for information
about physically adding or replacing a 45xx disk drive, see the 45xx Modular Disk
Subsystem Manual for G-Series Releases.
For procedures on how to stop a tape drive before physically removing it, see SCF
Reference Manual for the Storage Subsystem. For information about physically
adding, removing, or replacing an external tape drive, see one of the following:
•
5190/5194 Modular Tape Subsystem Manual
•
NonStop S-Series Hardware Support Guide
•
9490 Technical Reference Manual
For general information about Open SCSI devices and for information about physically
adding, removing, or replacing these devices, see the Open SCSI Integrator’s Manual