6763 Common Communication ServerNet Adapter Installation and Support Guide

Installing a CCSA

6763 Common Communication ServerNet Adapter Installation and Support Guide—522309-005

2-6

Install the CCSA

1. Disconnect the grounding clip of your ESD wrist strap from the antistatic mat, then

connect it to an unpainted metal surface on the CCSA.

2. Grasp the CCSA by its ejector in one hand, while supporting the bottom edge of

the CCSA with the other hand.

a. Carry the CCSA to the service side of the system enclosure.

b. Set the CCSA down on an antistatic mat rightside up with the ejector at the top.

3. Disconnect the grounding clip of your ESD wrist strap from the CCSA and connect

it to an unpainted metal surface on the service side of the system enclosure, such

as the ventilation holes on the processor multifunction (PMF) or I/O multifunction

(IOMF) CRU (see Figure 2-2).

Note. The CCSA weights 6.75 pounds (3 kilograms).

Figure 2-2. Ventilation Holes

Ventilation Holes on an IOMF CRU

VST081.vsd

Ventilation Holes on an IOMF CRU