6763 Common Communication ServerNet Adapter Installation and Support Guide

Installing a CCSA
6763 Common Communication ServerNet Adapter Installation and Support Guide—522309-005
2-8
Install the CCSA
5. Using both hands, hold the CCSA so that its ejector is at the top.
a. Carefully insert the adapter into its slot in the enclosure.
b. Push the CCSA to the rear of its slot, but don't force it.
6. Press the CCSA ejector latch down to seat the CCSA against the backplane.
7. Disconnect the grounding clip of your ESD wrist strap from the enclosure.
Caution. To avoid damaging the connector pins, apply equal pressure to both the top and
bottom of the CCSA when pushing it into its slot. If the pins are damaged, both the CCSA and
the backplane (or enclosure) must be replaced.
VST058.vsd