6763 Common Communication ServerNet Adapter Installation and Support Guide

Replacing a CCSA
6763 Common Communication ServerNet Adapter Installation and Support Guide—522309-005
3-6
Label the Communications Cables Connected to the
CCSA
4. Use the SCF STATUS ADAPTER command to verify that the CCSA ADAPTER
object is in the STOPPED state (see Example 3-3).
STATUS ADAPTER $adapter-name
Label the Communications Cables Connected to the CCSA
1. Find the group, module, and slot in which the CCSA is installed (see Figure 1-1 on
page 1-2).
2. Tag the communication cable connected to the CCSA with a physical label,
preferably at both ends. The label should include:
•
The physical interface (PIF) name assigned to the line. For example,
C2154.0.A
•
A description of the equipment and connector to which the cable is to be
connected
•
The slot location of the CCSA to which the cable is connected.
Replace the CCSA
Review Standard Operating Practices
See Review Standard Operating Practices on page 2-3 and Figure 2-1 on page 2-4.
Example 3-3. SCF STATUS ADAPTER Command
->STATUS ADAPTER $ZZLAN.C2153
SLSA Status ADAPTER
Name State
$ZZLAN.C2153 STOPPED
Table 3-2. Replacement Checklist
Step Description
1.
Review Standard Operating Practices.
2.
Unpack and Inspect the CCSA.
3.
Remove the Adapter.
4.
Install the CCSA
5.
Verify the Installation of the CCSA.
Note. Whenever you handle a CCSA, follow standard operating practices to avoid damage to
the equipment.