6763 Common Communication ServerNet Adapter Installation and Support Guide

Replacing a CCSA
6763 Common Communication ServerNet Adapter Installation and Support Guide—522309-005
3-11
Restart the Communications Lines
4. Use the SCF START LIF command to start the logical interface (LIF).
START LIF $ZZLAN.lif-name
5. Use the SCF STATUS LIF to verify that the LIF is in the STARTED state (see
Example 3-7).
STATUS LIF $ZZLAN.*
Troubleshooting
If the SCF STATUS SAC command shows that the CCSA SAC object is still in the
STARTING state after a few minutes or if the OSM Service Connection or TSM Service
Application indicates that the resource needs attention, follow the procedure described
in Troubleshooting on page 2-16.
Restart the Communications Lines
Refer to your application guides for information on how to restart them.
Verify that the Communications Lines are Restarted
Refer to your application guides for information on how to verify that your
communications lines are restarted.
Resume Customer Applications
1. Perform any actions necessary to resume customer applications.
2. Notify end users that applications are now available.
Example 3-7. SCF STATUS LIF command
->STATUS LIF $ZZLAN.*
SLSA Status LIF
Name State Access State
$ZZLAN.L218 STARTED UP
Note. The actions required to perform this step depend on the customer's application.