9710 (StorageTek) Addendum for NonStop Servers

Addendum to the StorageTek 9710 for the Tandem Environment
Configuring the Compaq System for the 9710 Automated Cartridge Subsystem
6-20
• The product number 5190 also identifies the T16/5155/5159
DLTtape Drive FRU in the peripherals paragraph.
• The unit number for each T16/5155/5159 DLTtape Drive
FRU must match the SCSI ID configured during installation.
• Only one T16/5155/5159 DLTtape Drive FRU can be
attached to an MFC. The drive must use SCSI ID 5, which is
the default SCSI ID for drive FRUs arriving from manufacturer.
• When two T16/5155/5159 DLTtape Drive FRUs are attached
to a 3216 controller, the drives must have SCSI IDs 4 and 5. If
only one drive is attached to a 3216 controller, then the SCSI
ID must be 5.
• The PERIPHERALS paragraph allows two modifiers:
NOCOMPRESSION and COMPRESSION.
• Table 6-6 lists the subchannel address, assigned to each I/O slot
in a system cabinet and I/O cabinet for Himalaya K100, K200,
K1000, K2000, and CLX systems. Specify the subchannel
address in one of the following paragraphs:
♦ For an MFC, in the MULTIFUNCTION_CONTROLLERS
paragraph.
♦ For a 3216 tape controller, in the CONTROLLERS
paragraph.
• To determine the subchannel address required for each I/O
controller in the CONTROLLERS paragraph, use Table 6-6 or
the following formula:
♦ (subchannel address) = %10* (I/O controller number)