9710 (StorageTek) Addendum for NonStop Servers

 9710 for the Tandem Environment
Configuring the 5155/5159 Digital Linear Tape FRU for the Himalaya S series Servers 7 5
Examine the 5155/5159 Rear Panel
Examine the co
physical installation (see Figure 7-
Connect the SCSI Signal Cable
To connect the SCSI signal cable (Copper):
1. Connect one end of the SCSI cable to the bottom SCSI signal
on the 5155/5159 rear panel.
2. Snap the wire cable clamps into place to secure the cable.
3.
connector on the PMF CRU of the Himalaya S-
cabinet or the IOMF CRU of the Himalaya S-
cabinet. Attach the 68 pin side of the SCSI cable to the
passthrough terminator of either the PMF CRU or the IOMF
-replaceable unit
tape drive as well as other peripheral devices
through a SCSI ServerNet addressable controller (SAC) located in
board (PMB), a multifunction I/O board (MFIOB) that contains the
SCSI SAC, and a po
of a Himalaya S-