9710 (StorageTek) Addendum for NonStop Servers

Addendum tot he StorageTek 9710 for the Tandem Environment
Configuring the 5155/5159 Digital Linear Tape FRU for the Himalaya S-series Servers 7-16
Example 1: Defining and Adding a Tape Drive
Use the SCF ADD TAPE command to define and add a 5155/5159
tape drive to the system configuration.
Before issuing the ADD TAPE command, insure that the tape
drive is installed properly.
The following example adds a 5155/5159 Digital Linear Tape FRU,
“$TAPE0” to the system configuration.
->ADD TAPE $TAPE0, SENTO STORAGE, LOCATION (1,1,55),&
->PRIMARYCPU 0, BACKUPCPU 1,
The following are notes about this example:
• The LOCATION attribute specifies the location (group,
module, and slot) of the PMF CRU (adapter) to which the tape
drive is attached.
• The PRIMARYCPU attribute specifies the processor in which
the primary tape process should execute.
• The BACKCPU attribute specifies the processor in which the
tape process starts its backup process.
• The PRODUCT attribute specifies the product number that
identifies the model of the tape drive.
Note: Use the product number 5190 when configuring the
5155/5159 Digital Linear Tape subsystem.