9710 (StorageTek) Addendum for NonStop Servers

Addendum to the StorageTek™ 9710 for the Tandem Environment
The 5155/5159 Digital Linear Tape CRE and NonStop Kernel
9-9
specifies whether the path is the primary (-P) or the backup (-B).
DETAIL
returns all status information.
Wild-card characters are supported.
Examples Using STATUS SCSI
The following are examples of the STATUS SCSI command:
• To display the status of all Open SCSI devices on the system, type:
-> STATUS SCSI $*
• To display the summary status of the Open SCSI device $DEV00, type:
-> STATUS $DEV00
• To display the detailed status of the Open SCSI device $DEV00, type:
-> STATUS $DEV00, DETAIL
• To display the summary status of the backup path of the Open SCSI
device $SD00, type:
-> STATUS $SD00-B
Comparing PUP Commands With STATUS SCSI
The SCF STATUS SCSI command for Open SCSI devices replaces part of
the PUP LISTDEV command. Table 9-4 compares PUP commands with
the SCF STATUS SCSI command.
Table 9-4 PUP Command Replaced by SCF STATUS SCSI Command
PUP Command SCF Command
LISTDEV TYPE SCSI STATUS SCSI