9710 (StorageTek) Addendum for NonStop Servers

Addendum to the StorageTek™ 9710 for the Tandem Environment
The 5155/5159 Digital Linear Tape CRE and NonStop Kernel
9-21
Comparing COUP and PUP Commands With START MON
In the G-series releases, the SCF START MON command replaces COUP
and PUP commands.
If necessary, the storage subsystem manager starts the SMF master process
if it is not running. When the process is ready, the storage subsystem
manager puts the SMF master process into a STARTED state (the
equivalent of a PUP UP command).
The following table compares COUP and PUP commands with the SCF
START MON command. For a complete list of all PUP commands and
equivalent SCF commands for the storage subsystem, see Pup Commands
and Equivalent SCF Commands in the SCF Reference Manual for the
Storage Subsystem.
Table 9-7 COUP/PUP Commands Replaced by SCF START MON
Command
COUP/PUP Command SCF Command
COUP START PROCESS START MON
PUP UP
START POOL Command
This subsection describes the details about the START POOL command.
Use the START POOL command to make the storage pool available to the
applications on the system. The command syntax is:
START POOL $ pool-name
Wild-card characters are supported.