9710 (StorageTek) Addendum for NonStop Servers

Addendum to the StorageTek™ 9710 for the Tandem Environment
The 5155/5159 Digital Linear Tape CRE and NonStop Kernel
9-23
3. The CATALOGLOCATION volume of the storage pool
process (must also be enabled by the NonStop Transaction
Manager/MP (TM/MP) product).
• Use the STATUS command to verify that the storage pool process is
started.
• If the storage pool process is in the SERVICING state, use the RESET
POOL command followed by the START POOL command.
Comparing COUP and PUP Commands With START POOL
In the G-series releases, the SCF START POOL command replaces COUP
and PUP commands.
If necessary, the storage subsystem manager starts the storage pool process
if it is not running. When the process is ready, the storage subsystem
manager puts the storage pool process into a STARTED state (the
equivalent of a PUP UP command).
The following table compares COUP and PUP commands with the SCF
START POOL command.
Table 9-9 COUP/PUP Commands Replaced by SCF START
POOL Command
COUP/PUP Command SCF Command
COUP START PROCESS START POOL
PUP UP