9710 (StorageTek) Addendum for NonStop Servers

Addendum to the StorageTek 9710 for the Tandem Environment

Installing and Configuring the 9710 Automated Cartridge Subsystem

3-2

3.3 Before Starting

Installing the 9710 Automated Cartridge Subsystem requires no

special tools. If the ID switch setting on the rear panel needs to be

changed, a pen will be needed.

If problems are encountered during the installation, see Table 2-4

for troubleshooting.

3.3.1 Installation Setup

The steps for installation setup are:

Step

Action

1 Unpack and check the shipment

Choose a site for the 9710 Automated Cartridge Subsystem

3 Use PUP to “Down” the controller(s) to which the 9710 Automated Cartridge

Subsystem’s DLT tape drive(s) are to be connected.

NOTE: For S-series installations, refer to Chapter 7

3.4 Site Setup

The 9710 Automated Cartridge Subsystem will require one (1) 20

AMP AC power circuit for DLT drives 1 through 6 and second 20

AMP AC power circuit for DLT drives 7 through 10.