9710 (StorageTek) Addendum for NonStop Servers

Addendum to the StorageTek 9710 for the Tandem Environment
Installing and Configuring the 9710 Automated Cartridge Subsystem
3-22
3.18 Connecting Copper Cable to the Drive FRU SCSI PORT (MFC
Only)
On the Patch Panel each drive FRU contains, one 68-pin SCSI port
and one 50-pin SCSI port. For a drive FRU controlled by an MFC,
copper cable links the 50-pin SCSI port with the MFC RS-232/SCSI
BIC. A SCSI terminator covers the other port. See Figure 3-13.
Install the copper cable connector to the SCSI port as follows:
1. Align the 50-pin cable connector with the SCSI port on the right
while facing the rear of the drive FRU, press firmly to seat the
connector.
2. Fasten the clips.
3. Make sure a SCSI terminator is firmly installed on the SCSI
port on the left.